Products
Testing Measuring & Laboratory Instruments
Electronics Lab Training Modules
Digital Electronics Lab Training Modules
Basic & Advance Communication Lab
Power Electronics Lab Training Module
Physics Lab Experimental Setups
Instrumentation Lab Training Modules
Control Lab Training Modules
Bread Board Trainers
Dynamic Demonstrators & Trainers
Microprocessor & Microcontroller Lab
Electrical Lab Training Modules & Equipments
Microwave & Antenna Experimental Trainers
 
 
New Arrivals
 
Product Photos
 
Exibition
 
Home » Microprocessor & Microcontroller Lab » Microprocessor & Microcontroller Trainers ("LCD" Type)
 
Microprocessor & Microcontroller Trainers ("LCD" Type)
 
 
Back   I   Next
IC 16 - 8 x 8 Led Matrix Display Interface
  Feature:
 
  • 8x8 LED Matrix Display.
  • Display consists of 64 nos. of 3mm LED.
  • LED's are organized as Eight Rows & Eight Columns matrix.
  • All LEDs are buffered.
  • Connect to 8255 using 26 pin FRC Connector
  • User's Manual with Sample Programs.
 
 
IC 17 - Thumb Wheel Switch Interface
  Feature:
 
  • Two Digit Thumb Wheel Switch.
  • Thumb wheel switch can be set from 00 to 99.
  • Output of Thumb wheel switch is in BCD Format.
  • Connect to 8255 using 26 pin FRC Connector.
  • User's Manual with Sample Programs
 
 
SC 01 - 8255 PPI Study Card With FRC Cable
  Feature:
  • 24 bit I/O using 8255 Programmable Peripheral IC
  • All Input/Output ports pins are terminated on 3 eight pin terminals and 26 pin FRC Connector
  • All Input/Output ports are indicated by 3 mm LED.
  • Data lines from AD0 to AD7 are indicated by 3 mm LED.
  • Chip Select, A0, A1, Read, Write are indicated by 3 mm LED.
  • Hardware Single Step and Full Clock Execution mode are provided.
  • Single stepping can be performed using micro switch provided on board.
  • Using this study card all MODE experiment can be performed.
  • Interface 8085/8086 Kit using 50 pin FRC Connector.
  • User's Manual with Sample Programs.
 
 
SC 02 - 8253 Programmable Timer Study Card With FRC Cable
  Feature:
  • Three channel Timer/Counter using 8253 Programmable Timer Counter IC.
  • All Input/Output ports pins are terminated on terminals and 10 pin FRC Connector.
  • Clock for Counter-0 is internally provided.
  • Data lines from AD0 to AD7 are indicated by 3 mm LED.
  • Chip Select, A0, A1, Read, Write are indicated by 3 mm LED.
  • Hardware Single Step and Full Clock Execution modes are provided.
  • Single stepping can be performed using micro switch provided on board.
  • Using this study card all MODE experiment can be performed.
  • Interface 8085/8086 Kit using 50 pin FRC Connector.
  • User's Manual with Sample Programs.
 
 
 
Top |   Back  I   Next
 
Home  |  Products  |  Authorized Dealers  |  Channel Partners  |  Our Clients  |  Contact Us
© 2011 Mars EdPal Instruments Pvt. Ltd. All rights reserved.