|
|
|
| |
Microprocessor & Microcontroller Trainers ("LCD" Type) |
| |
| |
|
|
IC 10 - 16x1 LCD Interface With FRC Cable |
| |
| |
Feature: |
|
| |
- 16x1 Liquid Crystal Display.
- Two 16 rows Alphanumeric Characters will be Displayed.
- Facility for backlite display.
- Connect to 8255 using 26 pin FRC Connector.
- User's Manual with Sample Programs
|
|
|
|
| |
IC 12 - Traffic Light Interface With FRC Cable |
| |
| |
Feature: |
|
| |
- Single Square traffic light display controller
- East, west, north, south posts are defined on the PCB for the square.
- For each post four LED is provided in Red, Yellow & Green color.
- Connect to 8255 using 26 pin FRC Connector.
- User's Manual with Sample Programs.
|
|
|
|
| |
IC 13 - Temperature Measurement Interface with FRC Cable |
| |
| |
Feature: |
|
| |
- ADC-0809 is used for Analog to Digital Conversion.
- 8 bit accuracy ADC chip A/D Conversion time is 100 micro sec.
- Op-amps are provided for signal conditioning of output from sensor.
- K-type thermocouple is used for the measurement.
- Thermocouple sensor is supplied with the module.
- Variable pot is provided for adjusting gain and offset.
- Temperature measurement max. up to 99°C is possible
- Connect to 8255 using 26 pin FRC Connector.
- User's Manual with Sample Programs.
|
|
|
|
| |
IC 14 - DC Motor Interface With Motor With Power & Supply FRC Cable |
| |
| |
Feature: |
|
| |
- DAC-0800 is used for Digital to Analog Conversion.
- 8 bit accuracy DAC chip
- SPDT Relay is provided for direction control
- Clock Wise & Anti Clock wise rotation can be controlled
- Speed can be controlled by this controller
- 9 Volt DC Motor is supplied with this card.
- 9 Volt AC Adaptor is supplied with this card.
- Connect to 8255 using 26 pin FRC Connector.
- User's Manual with Sample Programs.
|
|
|
|
| |
IC 15 - Relay & Opto Interface With FRC Cable |
| |
| |
Feature: |
|
| |
- Four SPDT Relays are provided.
- Relay outputs NO, NC, COM is provided at Screw Terminals.
- Four Opto isolator inputs are provided using MCT2E.
- Opto Inputs are provided through 10 pin FRC Connector.
- Connect to 8255 using 26 pin FRC Connector.
- User's Manual with Sample Programs.
|
|
|
|
| |
|
|
| |
|
|
